load tables tongue and groove floor decking

wcd 2 - tongue and groove roof decking - american wood council timber tongue and groove decking is a specialty lumber product constituting an tongue and groove wood roof decking including span and load tables.

plywood design and application guide - pfs·teco similar information for plywood used as wall and roof sheathing. section 4 .. are manufactured with a square edge or tongue-and-groove (t&g) edge.. table 5. recommended uniform floor live loads for floor span. with strength axis

engineered wood construction guide the recommendations for roof sheathing in table 34 apply to apa rated tongue-and-groove edges panel edge clips (one midway* between each . stiffener load-span tables for preframed apa panel roof decks.

span tables - county of san diego span tables. building floor joists . 2 blocking may be omitted if plywood edges have approved tongue and groove joints if ” minimum thickness.

2 x 6 timber decking - structural wood systems 2 x 6 solid timber decking by structural wood systems (sws) provides the american institute of timber construction standards for tongue-and-groove heavy loads shown are for dry use conditions multiply by .9 for wet service factor.

chapter 23 - wood - international code council beveled tongue-and-groove or u-shaped joints. 2303.1.5.2 roof insulation. loads and spans for service as floor and roof sheathing . floor sheathing conforming to the provisions of table. 2304.7(1) tongue-and-groove decking shall.

standard for tongue-and-groove roof decking - american institute standard for tongue-and-groove roof decking aitc 112-93 7 table 4. two inch nominal thickness''. allowable roof load limited by

tougue and groove roof decking - american wood council allowable roof load limited by deflection - .. 8. tongue and groove roof decking. table 1. two inch nominal thickness - allowable roof load

roof and subfloor sheathing spans - republic mo table r503.2.1.1(1) – allowable spans and loads for wood structural is 48 inches) tongue-and groove panel edges or other approved type of edge support.

engineered wood construction guide recom mended live loads are given in table 15. tongue-and-groove edges are recommended to be glued under thin floor coverings to assure snug .. deck can be walked on and will carry construction loads without damage to glue bond.